Stainless Steel Cable Tie---SS316 Trefoil Stainless Steel Cable Cleat Short Circuit Proof Approved

• Certification: RoHS, Short Circuits
• Color: Metallic
• Surface Treatment: Electroplating
• Usage: Electrical Appliance
• Material: Stainless Steel
• Type: U Type
• Model NO.: BZ-C Cable Cleat
• Transport Package: Carton
• Specification: 17~129mm
• Trademark: XIXI
• Origin: China
• HS Code: 73269090
• Production Capacity: 50, 000 Per Week

Product Description

Product Information:
•Device designed to provide securing of cables when installed at intervals along the length of cables
•For fixing, retainning, supporting & securing cables in trefoil or single formation.
•Protecting cables from short circuit faults(see detail information below)
Short circuit current is an overcurrent resulting from an electrical fault of negligible impedance between live
conductors or between a live conductor and an earth, having a difference in potential under normal operating
conditions.
- RMS current is a calculated value for the initial cycles of the fault.
- peak(ip) short circuit current is a maximum possible instantaneous value of the short circuit current.
- Electromechanical Force(Ft) is included forces acting on current carrying conductors.
- Relevant Standard : BS EN 50368 & IEC 61914 : 2015
a. Cable Cleats and intermediate restraints shall comply with the performance requirements in Article 398.2(d)
of NFPA-70-2005, The National Electrical Code Cable Cleats and intermediate restraints (where used) shall
be classified, tested and certified according to the European Specification IEC 61914 : 2009, Cable Cleats
for Electric Installations, as follows
i. Classified according to material as Metallic, or Composite (e.g. metallic Cable Cleat with an LSF liner)
ii. Classified according to resistance to impact as 'Very Heavy'(i.e. 20J impact energy @ 400mm height)
iii. Classified by an independent third-party testing laboratory in relation to resistance to electromechanical
forces as video:
sustaining two successive short circuits and there shall be no cuts or damage to the outer cable sheath,
and the cables shall meet the requirements of the voltage withstand test)